Steve,
You are mainly checking for solder bridges in that test, and a solder
bridge in much more likely between pins 1 and 2 than it is between 1 and 40.
73,
Don W3FPR
Steve Howard wrote:
> On page 21 of the K1 manual it says to check the adjacent pads on U1
> Does that mean checking across ?
> for ex pin 1 to pin 40 , pin 2 to pin 39 etc or does that mean
> pin 1 to pin 2, then pin 2 to pin 3 etc
> thanks,
>
> Steve
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
